The GFC-50’s default MIDI channel is channel 1. If you wish to change the default
channel, follow this procedure:
* The MIDI channel you set will not be stored in memory. It will be necessary to set the MIDI
channel each time the unit is turned on.
1. Switch on the unit while holding the Number Shift Pedal (A/B) down.
2. Select the desired MIDI channel using the Bank Shift Buttons (UP/DOWN).
(The Bank Display shows the MIDI channel currently selected.)
fig.13
* When any of MIDI channels 10 to 16 is selected, the Dot in the upper left hand corner of the
display will light.
3. Press the Number Shift Pedal (A/B). (The MIDI channel has now been set.)
Model: GFC-50 Version: 1.00
1. TRANSMITTED DATA
●Control change
Status Second Third
BnH ccH vvH
n = MIDI channel number 0H - FH (ch.1 - ch.16)
cc = Control number 07H, 10H, 40H, 50H (7, 16, 64, 80)
vv = Control Value 00H - 7FH (Prog.1 - Prog.128)
This message can be transmitted when the external pedal is connected.
●Program change
Status Second
CnH ppH
n = MIDI channel number 0H - FH (ch.1 - ch.16)
pp = Program number 00H - 7FH (Prog.1 - Prog.128)
This message is transmitted when the patch of GFC-50 is changed.