Peter, I desperately need your help! (SOLVED)

Whatamada

Member
Greetings on this sad day.

I went to put some fresh tubes in my Herbert today, he´s been sounding a bit tired lately.
Went through protocol with changing tubes, I have the one with external bias, just to discover that the first point of biasing isn't reading anything. It´s stone dead :no:
The other two are working just fine.

What should I do!?
I´m completely heart broken here and dreading the worst.

Please help me Peter Diezel, you´re my only hope :cry:

All the best,

Ulf
 
I dont think the fuse is the issue.
Since the fuse is removed when measuring the mA that shouldn't be a factor. Right? :S
 
Send an e-mail to Diezel. Typically that is the response Peter will give when he replies to these type of situations.
 
gaskocher":2xtru5l7 said:
Mind to share the solution?

Sure! I e-mailed Peter who was awesome as usual and described that it might the screen resistors on tube 1 and 6 are broken
or the clamps in the sockets are not tight enough.
Then he sent me a guide to give to my tech so he´s working on it right now :)

Cool beans!
 
Back
Top