crankyrayhanky
Well-known member
I just landed a Fractal fx8 which sounds wonderful with my DMoll.
I am trying to set up my program changes and hit a frustrating wall; the changes only work like 50% of the time
For example:
I hit scene 5 on fx8 which should be PC1 (amp channel clean 1).
Scene 1 which should be PC3 (amp channel hi gain ch3).
Scene 6 which should be PC2 (amp channel mid gain ch2).
clean channel works, then hi gain works, then go for clean and it does not work, it stays hi gain. I hit mid gain which works then clean and now suddenly clean works again.
I am now reading that sometime 2 high end midi pieces may not communicate and cause such issues (?)
Is my DMoll midi chip in need of an upgrade?
It worked fine with Joyo PXL, but these issues with the fx8 make it unusable.
Any help appreciated!!
I am trying to set up my program changes and hit a frustrating wall; the changes only work like 50% of the time
For example:
I hit scene 5 on fx8 which should be PC1 (amp channel clean 1).
Scene 1 which should be PC3 (amp channel hi gain ch3).
Scene 6 which should be PC2 (amp channel mid gain ch2).
clean channel works, then hi gain works, then go for clean and it does not work, it stays hi gain. I hit mid gain which works then clean and now suddenly clean works again.
I am now reading that sometime 2 high end midi pieces may not communicate and cause such issues (?)
Is my DMoll midi chip in need of an upgrade?
It worked fine with Joyo PXL, but these issues with the fx8 make it unusable.
Any help appreciated!!
