No sound from VH4 when using pedals. -solved-

O731

New member
Whenever I use my pedals on my Diezel VH4 I seem to be getting no sound. I tried removing the series loop too, and no luck. I just hear the idle hum noise from my amp.

Is it possible that my amp power supply is overloaded? I have a pretty decent one: https://www.amazon.com/gp/product/B072H ... UTF8&psc=1

These are all my pedals: https://imgur.com/a/OAgEP

My setup is:
guitar-->Tuner--> Noise Supressor--> Octaver--> Whammy--> Fuzz--> OD/Boost--> EQ--> Amp

My series loop is:
Send->Chorus--> Reverb--> Delay-> return

If anyone can help me out it will be very much appreciated!
 
There is a simple solution. Start with 1 pedal and 1 cable, then add the next to chain until you face the problem.
Then find out whether it is the patch cable, the pedal or the power supply by changing stuff around.
 
Vin Diezel":83f6n3xm said:
There is a simple solution. Start with 1 pedal and 1 cable, then add the next to chain until you face the problem.
Then find out whether it is the patch cable, the pedal or the power supply by changing stuff around.


Thank you! I'll check it out later today.
 
Vin Diezel":zlk24tuq said:
There is a simple solution. Start with 1 pedal and 1 cable, then add the next to chain until you face the problem.
Then find out whether it is the patch cable, the pedal or the power supply by changing stuff around.


It worked! Turns out the DC cable in my fuzz pedal was a bit too big for the socket.
 
Back
Top