bsp01
New member
So I switched my bridge from the stock "EVH" korean floyd to a OFR. No problem there.
I'm having a bitch of time getting set back up the way it was though. Is the bridge supposed to sit parallel in the little recess, or is it ok to have it angled upward a little bit? When it is sitting parallel in there the guitar buzzes and seems to fret out in spots. The only way for it to sound clear is to raise the bridge up.
It just seems like the bridge should not be angled like that .. like this | \ Where | is the post and \ is the edge, of course the angle is very exaggerated there. I would think it should be | --- like that.
Do I need to shim the nut a bit? I don't know what I'm doing here. Oh, I did try to adjust the truss rod a little to add some slack, but that didn't help much.
I'm having a bitch of time getting set back up the way it was though. Is the bridge supposed to sit parallel in the little recess, or is it ok to have it angled upward a little bit? When it is sitting parallel in there the guitar buzzes and seems to fret out in spots. The only way for it to sound clear is to raise the bridge up.
It just seems like the bridge should not be angled like that .. like this | \ Where | is the post and \ is the edge, of course the angle is very exaggerated there. I would think it should be | --- like that.
Do I need to shim the nut a bit? I don't know what I'm doing here. Oh, I did try to adjust the truss rod a little to add some slack, but that didn't help much.