Bogner Lindhurst Problem...

I just recieved my Lindhurst Compressor about three weeks ago. Last night at rehearsal, there was a slight squeek from my amp which I acredited to bad Power... However when I tried to turn on the compressor, the signal died all together and there was a massive hiss and a still louder squeek. When I exclude the pedal from the effects chain everything works fine so I know the problem lies with the Lindhurst. Could it be a bad switch? A bad solder joint to the switch maybe? Anybody else have a similar problem?

Thanks!

What's your power source? Battery or wall wart or pedal power? Are you sure it's getting correct amperage?

How many mA does it need?

Don't know but it runs on a battery too so you can test that way and since it runs on a battery it's probably not the issue. I think bogner recommends this as of the first pedals in your chain, before any buffers so you might try changing effect order if it isnt...