Help setting up Reload with UAD Apollo Twin ?

C

CalZach

New member
Hi there,

I've been struggling to get things set up - possibly because I'm not routing things properly in the UAD console but I'm not sure. Does anyone here have these 2 devices?

I can record the DI signal fine, but if I try and get the load box output to also record at the same time then I just get a high-pitched noise on the channel :-/

Is anyone able to walk me through it?

I checked and re-checked the physical cable connections, so as certain as I can be that they are correct

(using a Mac if that makes any difference)

thanks
 
You would need to assure that the DI signal is routed to the 3-4 output and send one of those back to the replay input. The loadbox output is recorded on a separate track from the DI output and that output goes to your monitors with the WOSIII instanciated.
 
Aha! Right, I *had* done all that, but I needed to set Output 3/4 to 'Output 3/4' in Cue Outputs (defaults to 'Monitor')

It was driving me bonkers - all sorted now, and the profile saved.
 
You must log in or register to reply here.
Back
Top