Recent content by marl3y

Make sure to check the polarity of the plug too.

Good to know. I bought used, so presume mine's not potted. Might have to look into that. Thanks a lot.

I have a Knaggs that came with the Candy set. They sound nice, but are really hard to control. With any kind of gain they really like to squeal.

I have a PS-2 and would like to use it to send line level signal from the reactive load into the wet channels of a W/D/W setup. It doesn't have a control to adjust the line level output like a PS-2A does. Anyone know if it's possible to make this conversion to turn a PS-2 into a PS-2A? Thanks.

Been a while, but I built mine in '07 using Onetics PT/OT. To this day, after probably 20+ builds, it's still my favorite. This was the only SLO clone, so surely some of that is my taste for that circuit, but if I were doing it again I'd go Onetics for sure. Good luck.

This is correct. The input stage (V1) is located in the amp, closest to the input jack. Only half of this triode is used, and the cathode bias/bypass for this stage is set by the module via the three-position switch, as Shask has described above. The tubes in the module are subsequent gain...

For me is was Gary Moore - We Want Moore! at the top of the list.

Yep, I run it through a Power Station. Awesome combo that can cover a lot of ground.

Correct the input stage is "in the amp", not the module. The three-position switch on the module tells the amp which cathode resistor/bypass capacitor to use. It does make a difference, I added a manual switch to do this to an RM100. Stock Egnater/Randall products use the traditional Fender...

Looking for head, but would consider the combo. No preference on the cosmetic theme, but prefer one that's in good condition. Of course preference would be for one with a dual-channel mod, but I'm fine with making that upgrade too. Shipping these beasts is likely to be cost-prohibitive, so close...

Synergy module packed well, shipped quickly. Thanks.

bump

Ended up with two of these. Perfect condition, with box and original manual. Would like to trade for other Synergy modules, IICP, Herbert or Pitbull UL. Will sell for $300 shipped PP F&F. Thanks.

Here's hoping. Also, the test shown in the pic is a negative result.

Was just playing mine last week. Bought it back in '08. Loaded it with Svetlana 6550s and it just rips. Ingenious concept, well engineered and high quality build. Many years ago I had weak signal due to loop jack connectivity, but a quick clean remedied it and not a problem since. I also have a...