Recent content by morgansbluff

I knew about the treble zero thing. I was messing with that when I found this. Only thing is i keep the presence low with treble zero. If i turn presence up it adds a blanket effect. I know that sounds weird but i don't hear it adding highs until it is turned way up. That goes for treble at...

Mines a 2021. I play on old mode. Old setting has chewier mids and smoother highs. I keep the gain low and hit with a clean boost for higher gain. I use a boss ms3 clean boost, not sure what they modeled it after. For other songs I use an sd1. Sometimes a big muff into an sd1. It's always taken...

This explains it. All depends how you have it set

And yes about the half power. If you are running 16ohm load set your amp to 8 if at half power. 8 ohm cabs set to 4 ohm in amp 4 ohm cabs would be a no go Scott told me same with the half power switch too. Treat it as if you're pulling tubes. There's not a big volume difference in half...

I was messing with settings today and came across something I'd like to see if your quikrods do too. I did this pretty loud Gain 10oclock. volume 9oclock.mids 11oclock. Presence 9oclock. No loop master. If I turn the bass to maxed out and the treble off....as I slowly turn up treble to full...

I liked mine with v30s. Im currently running greenback and v30 mix but for no reason. I had no problem with the v30s just got bored.

Hold on. Daisy chaining to another cabinet could be parallel. Most of my cabinets are labeled parallel inputs. I always check with a voltmeter. Hook everything up and the cable that would go into your amp leave out and take a reading. Black on sleeve, red on tip. The amps 2 jacks are always...

It's inside yeah. Once I got it where I wanted it I never touched it again. It doesn't effect gear 1 or 3. Just gear 2. I've never heard a noticeable difference between tube brands. The only reason the mullards made a huge difference is because I am certain the original PS vanes were damaged...

I use the mid switch on with my v30s and off with my greenbacks. Sounds great.

THIS ?. the bass can get out of hand quickly. I did a slight mod to gear 2. I Put a variable resistor trim pot inside to fiddle with til it sounded right. Gear 1 and 2 now have similar bass response. I must say the biggest change I've heard is new power tubes. The stock psvanes flashed one day...

I'm not trading but I am selling the Bogner. I prefer the Splawn much more.

It's not the SE. He is willing to throw in a 200 case with it. After playing both amps over and over again I really can't make up my mind. I don't think I'm going to trade I like them both. I feel like I can get a guitar anytime. These amps aren't as easy to come by.

It's more compressed. The Splawn cleans up way better. I actually find the Splawn easier to play

All of em. Micro amp is cool cus it doesn't cut bass for leads. Big muffs can make the Splawn sing , scoops out the highs and sustains forever. I've been using the boss ms3 and every OD on there sounds good

I've been playing the quick rod as my main amp for almost a year now.i finally got the hang of the EQ. Bass low at indoor shows. I recently picked up a Shiva 20th anniversary. This amp rips too but a different flavor. The Splawn can get a little brittle sometimes where the Shiva is bright but...