This is an ongoing issue.
I purchased a Torpedo Studio, and have used it with three different amps. My amp is a Marshall JMP50 50 watt.
The Marshall was set at 2 on the volume scale (1-10) for a nice full clean tone.
The Studio input was set so that only the green leds would illuminate if...
I am really confused....this isn't anything new, I seem to get confused regularly. But reading the Two Notes Studio Manual is like reading greek tp me.
Anyway, I down loaded a set of the Ownhammer Impulse Responses and have no idea where to put them.
I am using an iMac.
I found the Impulse...
Thinking of getting a Classic T with Thoirnbuckers in the bridge and neck.
Anyone know if these will produce any twang at all? Perhaps 5 way switch with push/pull to split coils?
Don't play much traditional country but a bit of twang might be nice.
Uncle M
So I was thinking.... dangerous I know :)
Will the new Torpedo Studio have the capability to bypass/cut output to the cab/amp speaker and yet allow it to remain connected and still see the load as compared to having just a speaker pass through?
Having to reach behind the unit to connect and...
I would like to know what the availability of the Jim Kelly Reverb Head is. I see that the Suhr website indicates it is shipping, but I don't see that they are in stock at the dealers.
I was blown away with the sounds I heard in the Pete Thorn review.
Thanks
Just Say Uncle
Uncle Mike
I have purchased a Carr Sportsman Amp which is 16 ohms.
I see that the Torpedo Live is 8 Ohms. I would imagine that this has been asked but I have not been able to fine a complete answer. Reading the Manual indicates that when running a 16 ohm amp, a speaker cable should be connected to the...
I am thinking about picking up a used Torpedo until my order for the new Torpedo Studio is delivered which now appears to be pushed back until September.
My question is, if I do purchased a second hand unit, will I be able to access firmware updates, and other available features such as...
I recently received a new Suhr Modern with SSV/ML/SSH pickups.
How is 5-way switch is wired?
I assume that is:
1. Neck PU
2. Neck/Middle
3. Middle
4. Middle/Bridge
5 Bridge
Is this correct?
Thanks