3 dummy-questions concerning speaker load

  • Thread starter Thread starter eddiespaghetty
  • Start date Start date
E

eddiespaghetty

New member
1. If I turn on my amp without the speakers plugged in - what damage would that cause on the amp?

2. If I choose the wrong impedance - does it inevitable cause a damage?

3. If i turn on the amp, but leave it in standby - do I have to plug in the cabinet or could it be without?

Sorry for the questions, but I am technical completely unexperienced.

Cheers
 
1. If I turn on my amp without the speakers plugged in - what damage would that cause on the amp?
NONE AS LONG AS THERE IS NO SIGNAL GOING THROUGH IT.
2. If I choose the wrong impedance - does it inevitable cause a damage? IT CAN IF THERE IS TO BIG OF A IMPEDANCE MISMATCH. 1 OFF, NO NOT REALLY

3. If i turn on the amp, but leave it in standby - do I have to plug in the cabinet or could it be without? THIS IS PERFECTLY FINE

Sorry for the questions, but I am technical completely unexperienced.

Cheers
 
That was a fast as lightning-answer!

Thank you very much!
 
You must log in or register to reply here.
Back
Top