braintheory
Well-known member
So the other day I was in a bit of a hurry (had an appointment to go to) and was turning on my Naylor SD100 for a very quick run before leaving and accidentally put the speaker cable into one of the fx loop jacks rather than the speaker ones. I was like why is there no sound and quickly caught it after 10-20 seconds and turned the amp off. I then put it in the right place (speaker jack) and there was still no sound. All the tubes lit up, the power light lit up, fuses looked fine, even tried the tubes from it, same cables and guitar in my other amps and they’re all fine in the other amps, but for whatever reason I can’t get any sound out of the Naylor right now. Can anyone explain what could be wrong? Did I make a big mistake with accidentally plugging it in that fx loop briefly? I never had the volume on it set that high fwiw