DADA
Member
To all the owners of the axe-fx.
Had a longtime problem with uneven channel signal volumes. Lately it became worse bigtime. So I asked some help and advice.
Inside there are different connectors and while the most are sturdy there is one that is quite flimsy and easely gets loose. It is the small connector on the board connected to the Instr. Put an extra tai-rib together with the other 2 cables as close as possible to the on board connection. Now it will not come loose as easy.
Now you opened it up I advice to dis and reconnect also the other connectors.
My advice: Check this and thai-rib this!
And following this advise is at your own risk.
Had a longtime problem with uneven channel signal volumes. Lately it became worse bigtime. So I asked some help and advice.
Inside there are different connectors and while the most are sturdy there is one that is quite flimsy and easely gets loose. It is the small connector on the board connected to the Instr. Put an extra tai-rib together with the other 2 cables as close as possible to the on board connection. Now it will not come loose as easy.
Now you opened it up I advice to dis and reconnect also the other connectors.
My advice: Check this and thai-rib this!
And following this advise is at your own risk.