Bradshaw RSB question/ routing:

[Francorossi]

Hi @ all,

after some time of dialing and testing I have the following signal chain: Strat---Bradshaw RSB12 in-----Loop1 Cry Baby-----Loop2 Overdrive-----Loop3 DIY phaser (!!!)-----RSB out------TBR in-----send Intellifex------return Intellifex-------TBR power out--------4x12 cab..............what I´m asking is that I´m pretty sure that there are more sophisticated ways in routing the signal for more flexibility and /or TONE.......maybe another boost ( OCD?)or a second preamp (Soldano?) or an additional fx ( MPX1) to come.........Which way would you guys hook up the(se) unit(s)???

Any clue is highly appreciated!!!

 

[Dave L]

I´m not sure how the RSB handles line level signals or isolates the loops, since I´ve never owned one, but there´s always the possibility to stick the TBR´s preamp (using its input and loop send) and the additional preamp in the loop(s) after the last pedal and stick the rack FX units in the following loops... ending with the RSB out into the TBR loop return.

You might end up with noise issues, ground loops and what not, but I guess it can´t hurt to try it out.

 

[Francorossi]

Hi Dave,

this is what I assumed.......I can recall from the past that it is very well possible to handle different preamps and fx together with the TBR......I´ll check this in a quiet moment

Thank you

Franco

 

[Dave L]

Yeah, try it out! If there turns out to be any issues you can always address them in various ways, it´s always hard to predict how any given set of gizmos will work together.