Bulging Transformer on VH2?

  • Thread starter Thread starter dougywarren
  • Start date Start date
D

dougywarren

New member
Just noticed this today on my VH2. Everything seems to be sounding good and working right. I run the master around 9:00-10:00. I run it 8 ohms into my 2x12 or my Suhr Reactive Load IR.

Worth being concerned about? Bought it used and had it a little while. No issues as of yet.
 

Attachments

  • IMG_5115.jpeg
    IMG_5115.jpeg
    2.3 MB · Views: 15
dougywarren said:
Just noticed this today on my VH2. Everything seems to be sounding good and working right. I run the master around 9:00-10:00. I run it 8 ohms into my 2x12 or my Suhr Reactive Load IR.

Worth being concerned about? Bought it used and had it a little while. No issues as of yet.
Click to expand...
Just a bent end bell. I would take it out of the headshell and just give it a once over with a rubber mallet/hammer. But only if it aesthetically bothered me. If it’s not causing an audible vibration, I probably wouldn’t worry about it and only hammer it down if I was going to sell it.
 
skoora said:
Just a bent end bell. I would take it out of the headshell and just give it a once over with a rubber mallet/hammer. But only if it aesthetically bothered me. If it’s not causing an audible vibration, I probably wouldn’t worry about it and only hammer it down if I was going to sell it.
Click to expand...
Awesome thanks! Was hoping it was nothing. Maybe I knocked it when I took the amp out and in to reseat the tubes after shipping.
 
I would leave it alone. The screw forces the plate downwards at the edge. I doubt there is more to this.
 
You must log in or register to reply here.
Back
Top