Captor X fan&dust clean work?

[BZGS]

I have been using the unit for one year, and I have to say, it is really great, not just good, it is great!
However, I noticed that there is some dust on the heat sink part inside of the unit. How to clean it?
The first idea that comes to my mind is to use a vacuum towards the air-inlet grille in the front panel, and also hold the fan to stop its spinning due to the airflow (since it may generate a small current when spinning and may cause bad results to the circuit board). BUT I am not sure if the internal components are strong enough in this way. Any ideas? Thank you very much!

 

[Ventura]

I've just used a can of pressurized air - stick the plastic nozzle through the grill on the front, a couple of short blasts, dislodges/removes any dust build-up. Short n sweet. No sweat.

 

[Dilan - Two notes]

Hello @BZGS , as said by @Ventura , the best is to use a can of pressurized air to remove dust build-up. You will be able to clean your unit without opening it - you should never open your unit. Kind regards.

 

[BZGS]

Thank you @Ventura and @Dilan - Two notes, that's a good idea! I will give it a try!