5
515O_GUY
Member
Hello,
I'm new to this forum. I've been investigating building a WET/DRY rig.
I've found some helpful information online and in this forum as well but I'm still puzzled.
I've learned the benefits of slaving EVH 515OIII amps for the purposes of WET/DRY. I've learned that slaving the amps allows for consistent tone and setting ans control over balancing the WET and DRY mix. But one thing stumps me. HOW does one assign certain effects to the front of the WET amp and werain effects to the "REAR"/EFFECTS LOOP of the WET amp? The aim to be having ALL effects only in the WET amp and a completely DRY amp driving the rig with the aforementioned benefits of tone/settings consistency by slaving the amps in the rig.
MY AIMED RIG:
•2 EVH 515OIII 5OW Amplifiers (hopefully slaved - 1 amplifier completely WET, 1 amplifier completely DRY - mixing the sounds in air)
•2 RJM Mini Effect Gizmo X units (1st routing Pre-Amp Wah, Comp, Etc. Effects) (2nd routing Power-Amp Phaser, Harmony, Reverb, Etc. Effects)
•1 RJM Mastermind LT MIDI foot Controller (to asign presets that change amp settings and selected effects with a single foot tap)
If what I am looking to do is possible with the stated equipment (slaving the amplifiers) I would appreciate some insight as to best practices and where to start planning the routing for my desired rig.
If what I am looking to build requires more equipment (and can't easily slave the amplifiers) I'd equally appreciate some insight and suggestions how to achieve my desired rig.
Thank you very much and I look forward to learning a lot more here!
I'm new to this forum. I've been investigating building a WET/DRY rig.
I've found some helpful information online and in this forum as well but I'm still puzzled.
I've learned the benefits of slaving EVH 515OIII amps for the purposes of WET/DRY. I've learned that slaving the amps allows for consistent tone and setting ans control over balancing the WET and DRY mix. But one thing stumps me. HOW does one assign certain effects to the front of the WET amp and werain effects to the "REAR"/EFFECTS LOOP of the WET amp? The aim to be having ALL effects only in the WET amp and a completely DRY amp driving the rig with the aforementioned benefits of tone/settings consistency by slaving the amps in the rig.
MY AIMED RIG:
•2 EVH 515OIII 5OW Amplifiers (hopefully slaved - 1 amplifier completely WET, 1 amplifier completely DRY - mixing the sounds in air)
•2 RJM Mini Effect Gizmo X units (1st routing Pre-Amp Wah, Comp, Etc. Effects) (2nd routing Power-Amp Phaser, Harmony, Reverb, Etc. Effects)
•1 RJM Mastermind LT MIDI foot Controller (to asign presets that change amp settings and selected effects with a single foot tap)
If what I am looking to do is possible with the stated equipment (slaving the amplifiers) I would appreciate some insight as to best practices and where to start planning the routing for my desired rig.
If what I am looking to build requires more equipment (and can't easily slave the amplifiers) I'd equally appreciate some insight and suggestions how to achieve my desired rig.
Thank you very much and I look forward to learning a lot more here!
