Finished putting together my W/D rig and pedalboard

  • Thread starter Thread starter The Hoff
  • Start date Start date
Thanks guys. I'm seriously loving it all.

The CE-1 does take up a bit of real estate but I love it.

The pedalboard is from blackbird.

This is the diagram I made when I was planning it all:
rigdiagramcheck.jpg


I ended up going with a 2 unit Matrix GT1000FX but as I stated above-I ended up going the W/D route instead. So it is all the same except minus one 1x12.
 
What's keeping you from getting another 1x12 to complete the rig in the diagram? Should be sweet.
 
LukeCurd":201lyp9u said:
What's keeping you from getting another 1x12 to complete the rig in the diagram? Should be sweet.
Click to expand...
I actually have the 1x12. It just didn't make much of a difference (the difference between W/D to W/D/W).
 
Wow. .as clean as anything I've seen out there. Ever see rigs all set up and it makes you want to play on it? LOL. .looks like that! Sharp
 
The Hoff":2c8ti9f2 said:
LukeCurd":2c8ti9f2 said:
What's keeping you from getting another 1x12 to complete the rig in the diagram? Should be sweet.
Click to expand...
I actually have the 1x12. It just didn't make much of a difference (the difference between W/D to W/D/W).
Click to expand...

It's super cool for doing the stereo ping-pong delay thing like Brian May. I run dry signal in the center and then 550ms wet, no repeats in the left, and 1100ms in the right. It gets you into the trance zone in no time flat. One of my favorite things to do with a W/D/W.
 
Very clean and mean! Love the tweed edging on the board.

Well done!

:)
 
Nice clean work!....makes me wanna go back and make my own board better!
 
yngwiestrat":3jvyde96 said:
POG 2 up front or in the loop?
Click to expand...
I put it up front. Played around with different spots but liked it there best.
 
Thank guys. I had a fun time putting it all together and wiring it up. Not sure if it was only fun because it was my own board but I seriously had a good time. Wish I could find a shop to work at locally and do it for some extra cash on the side or something.
 
The Hoff":2u3y7czh said:
Thank guys. I had a fun time putting it all together and wiring it up. Not sure if it was only fun because it was my own board but I seriously had a good time. Wish I could find a shop to work at locally and do it for some extra cash on the side or something.
Click to expand...
i wish i still had my ce-1 sometimes along with my ada and mxr flangers!
 
You must log in or register to reply here.
Back
Top