Footswitch trouble: Blue LED on ch1 mode1 burnt out ?

[tripstan]

So I have an Enistein with the Ch. 1 mod. Looks to me that the pedal is a kit from Diezel or a well made version guided by Diezel Inc. The blue LED on the clean ch. mode 1 burnt out. I got a replacement and touched the two ends to where the other one is and it got blue the REALLY white then burnt out. It has switching for each mode. With a blue LED for the clean and a red for the mega/hotrod marshall (mode 3) no LED for crunch. All switching still works, just no LED on my clean channel. It also has a link switch at the top so u can automatically switch to CH. 2 and Master Vol. 2 at the same time, or back to CH. 1 with Master Vol 1. I'll try to post pics if I can but I've been having trouble with my camera.

I'm wondering if something else is also burnt or if just placing the LED on there to so if it works was a bad idea. There are two small resistors? or something also attachted to this LED, maybe one of those is bad? I did the trouble shoot with the footswitch NOT plugged into the amp just in case this in a The amp still works great and footswitching still works fine after I tried that. Just kinda stuck at the moment. Don't wanna send the switch in for a silly little soldering job.

 

[Peter Diezel]

Sorry, we did no modification to the channel switching.
Who was that ?

 

[tripstan]

I'm not sure, it has a Diezel sticker on the front of the foot switch. I purchased the amp and footswitch from a guy in Las Vegas. I believe the mod was done there and the footswitch was made there as well. He was the second owner, and I think the serial # is 003/317. I will double check serial # and post a pic of the inside as well as the troubled spot. The build quilty of the footswitch looks top notch thats why I said it could possibly be done by Diezel or the schematics was given out by Diezel Inc. I'm just trying to replace the LED with out it burning out right away again.

Thanks again, Pops

Sorry I wanted to say that you can switch between Master Vol. 1 & 2 on each Channel still. The amp has not be modded to set MV 2 to only the Lead channel. Einny was only modded for the mode switching of channel 1. I was trying to say the footswitch has a option (a 'link' switch at the top) to designate master vol 1 to ch. 1 and master vol 2 to ch. 2, So when you switch from channel 1 to the Lead channel you automatically get the lead channel with Master 2. Does that make sense? I will post pics tonite. I was thinking of buying the voodooman switch but the FS i have now has TRS input jacks on the pedal. Works great cause I can level the pedal on my board and just disconnect the two cables, and close up my pedalboard.