G-major 2 - volume drop when switching patches

[Bash_Man]

hey everyone,
So I've got a G-major 2 that's in the loop of my Egnater Armageddon and its all programmed by the Voodoo Labs Group Control Pro.

I have 4 sounds (4 bottom buttons row) that change from Clean, OD, Highgain highgain with Mid boost and delays.

I've I've noticed is when switching from any of the channels with an effect engaged, there's this sudden drop in volume to pretty much 0 and its about a .5 second drop then signal comes on full with no issue. This issue doesn't occur when I don't have any effects engaged and its just the dry sound on the amp.

Anyone come across this? and is there a fix?

Thanks

 

[Bash_Man]

Any one by any chance?

Thanks

 

[Shask]

I have one, but don't use it enough to have an answer, lol.

Do you change configurations? I know if you change the routing it can create a gap. Like series to parallel or something. It works better if you keep the routing locked to one configuration. I know that the phaser can create a gap also. Like, if you switch the phaser on and off.

 

[Bash_Man]

I have one, but don't use it enough to have an answer, lol.

Do you change configurations? I know if you change the routing it can create a gap. Like series to parallel or something. It works better if you keep the routing locked to one configuration. I know that the phaser can create a gap also. Like, if you switch the phaser on and off.

The 4 patches I use are programmed exactly the same. In fact they're an exact copy of each other.

I'll check the routing setting. I was also reading suggestions on other forums to check the signal whether it's set to Consumer or Pro.

It's really weird cause it doesn't always happen, and when it does it happens with any effect ON, not only Phaser.

Thanks