g system question....

[The_Kid]

if I'm wanting to hook up my talkbox to a separate amp how would this work??

Before I would just use a A/B box to split right after the guitar to two separate amps....


I assumed I could run Loop 4 to the talkbox amp and then run that amp to the talkbox. When I do this I get no signal....why wouldnt this work? I have a patch setup with the all loops except 4 turned off... ???

 

[Stratboy151]

if I'm wanting to hook up my talkbox to a separate amp how would this work??

Before I would just use a A/B box to split right after the guitar to two separate amps....


I assumed I could run Loop 4 to the talkbox amp and then run that amp to the talkbox. When I do this I get no signal....why wouldnt this work? I have a patch setup with the all loops except 4 turned off... ???

are you just sending out from loop 4 and not returning? i believe the loop wants to see the circuit closed thats why you get no signal i would imagine. also im not sure if when you use both outputs there is a way to mute 1 in the settings and allow the other to play? might wanna read up on that route instead of going thru the loops

 

[The_Kid]

i thought that you could set which patches are 50/50 and so on...so I'd just make my patches 100/0 and 0/100 for the patches needed.

I'd do Left to my JSX normal sound and Right to my talkbox amp....

Reason I'm trying this route, is then I can put the talkbox pedal in my rack...and switch it on and off from the gsys pedal via the loop buttons....

 

[Stratboy151]

i thought that you could set which patches are 50/50 and so on...so I'd just make my patches 100/0 and 0/100 for the patches needed.

I'd do Left to my JSX normal sound and Right to my talkbox amp....

Reason I'm trying this route, is then I can put the talkbox pedal in my rack...and switch it on and off from the gsys pedal via the loop buttons....

well theres your answer! im trying to figure out how to incorporate another piece of gear using the gsystem. for example, if i wanted to use the gforce(which a buddy of mine wants to donate to me) how would i hook it up so the G controlled it, and if i use a loop the Gforce wouldnt be placed in the Amps effect loop. so im stumpd..

 

[The_Kid]

I'm not sure where to find the output selections for patches...I've looked briefly.....


Also, if I have any stereo type effects on, will that sound like shit when on my normal sound?