GCX routing - will this work?

[Markedman]

I have a Ground Control Pro & GCX that I will use to switch between my TriAxis, Quad Preamp, fx loop, and "Midi" switches on the Quad.

I want to run cables from my tc electronic corona chorus' stereo out, which is the last effect on my board, one to the TriAxis and one to the Quad inputs. From there I would come out of the fx sends of the preamps into the "in" & "return" of loop1 and then out to loop 2 in, loop "on" would be the TriAxis, loop "off" would be the Quad. From there, loop 2 out would be my fx send to a delay and reverb. Coming out of loop 2, I will send that to the front of the GCX to split the signal to go to the stereo inputs of the amp.

The last six loops would go to the Quads "midi" switches to change channels on the Quad.

*The Quad is getting a check up, hopefully it will be back on Wednesday, I bought the GCX on Reverb and will be here this week, maybe Wednesday, so I can't just wire this up and try it out yet.*

 

[stratjacket]

Hard to follow the signal flow from the description. Have you tried to print their planning diagram and draw out what you want to do?
If you can post a pic of that design, could try to help. Chances are once you draw it out, you’ll know if it will work or not.

 

[stratjacket]

The diagram:

http://www.voodoolab.com/gcxdiagrams/blank_gcx_worksheet_l.pdf

 

[Markedman]

God diagram by John Bazzano, on Flickr

 

[Markedman]

I'm going to put a mute in line after fx loop.