JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
For Sale GZ Hellion Headshell Orange
Thread starter
Thread starter
MetalHeadMike
Start date
Start date
Jul 19, 2025
To buy, sell, or trade in this section, you must have at least 50 posts and have two-factor authentication enabled.
MetalHeadMike
Well-known member
Headshell and rear cover for a Ground Zero Hellion. Badge or chassis bolts are not included.
$175 shipped PPFF.
IMG_1668.jpg
2.1 MB
· Views: 67
IMG_1669.jpg
2.2 MB
· Views: 59
IMG_1670.jpg
2.1 MB
· Views: 55
IMG_1671.jpg
2 MB
· Views: 54
IMG_1672.jpg
1.8 MB
· Views: 53
IMG_1673.jpg
1.7 MB
· Views: 66
Exo-metal
Well-known member
That is nice. Makes me wonder if it would fit a jcm 800.
MetalHeadMike
Well-known member
That is nice. Makes me wonder if it would fit a jcm 800.
You just made me wonder if it would fit the Super Trem coming...hmmm
Exo-metal
Well-known member
It won't work on a jmp...but a jcm 800 series is another question.
Last edited: Jul 19, 2025
RedPlated
Well-known member
Hellion shells are same dimensions as 1987x Marshall. The front opening is wider, but it’s around 24”.
100w Marshalls chassis are a little over 26” wide.
Exo-metal
Well-known member
Even if they fit the faceplate doesn't span the opening.
MetalHeadMike
Well-known member
Even if they fit the faceplate doesn't span the opening.
That's an easy manipulation I'd think.
Exo-metal
Well-known member
I don't. How would suggest making the original faceplate of a jmp span the entire opening and make it look good?
John4021
Well-known member
Do you have any gut shots?
( Hey brother, no Naked Bea pics included huh?)
MetalHeadMike
Well-known member
I don't. How would suggest making the original faceplate of a jmp span the entire opening and make it look good?
My bad, I was thinking you meant the nameplate. Yeah you'd have to get creative.
MetalHeadMike
Well-known member
MetalHeadMike
Well-known member
RedPlated
Well-known member
This could actually make a good rack case for a few units. I made one using an old XTC shell.
IMG_2206.jpeg
4.8 MB
· Views: 31
MetalHeadMike
Well-known member
What are the inner dimensions of the cab?
MetalHeadMike
Well-known member
What are the inner dimensions of the cab?
24.5"L x 8"H x 7.25"D-to the inside of the face where the logo would be.
Up
MetalHeadMike
Well-known member
MetalHeadMike
Well-known member
Bump
The orange headshell adds Marshall mids, more low end, and lets you hear every note when pounding complex power chords. One of the cheapest mods out there I think for what you'll get.
MetalHeadMike
Well-known member
MetalHeadMike
Well-known member