Herbert - using balanced gear in the loops

[dhare]

I am interested in purchasing a Demeter RV-1 spring reverb unit for my Herbert, I want to use it in the serial loop or switchable loop.

however it has balanced inputs and outputs (both 1/4 inch, and XLR are available) , with this cause any issues or an impedance mismatch since the loops on the Herbert are unbalanced?

Or is any special wiring needed between the two to minimize noise / hum, etc?

specs for RV-1:
Input impedance 10k ohms
Output impedance 10 ohms

Herbert:
Output impedance 4.7k ohms

Thanks,
Dave

 

[Jens Kruse]

I'm checking this out for you, Dave.

Cheers,

Jens