Line Out Box recommendation

[LLEADD]

I'm looking at the Bray one because it's under $50 but the Suhr and CAE ones are $150. Do you think it's a quality get what you pay for thing or from what read you can also make a line out for under $10? I'd like to just buy one once but at the same time not spend an extra $100 for a name or whatever.

 

[voodooel34]

I have the Suhr. Works great.

 

[lowmantotempole]

I have the Suhr. Works great.

Same here. I run that line directly into my DAW and use IRs. Sounds great!

 

[LLEADD]

I take it should be transparent?

 

[Jet Troop]

Any difference between the suhr and the bray to justify the extra $130? I would like to purchase one soon.

 

[LLEADD]

I think I'm going to try out a Bray.

 

[LLEADD]

I ordered a Bray.
So if I go speaker out of my plexi (I only have one speaker out) into the line out box, out of that into....a 2nd amps send, then the effects rack, then the 2nd amps return, then out to the cabinet?
Or do I have to go into the 2nd amps input?

 

[tfridgen]

I ordered a Bray.
So if I go speaker out of my plexi (I only have one speaker out) into the line out box, out of that into....a 2nd amps send, then the effects rack, then the 2nd amps return, then out to the cabinet?
Or do I have to go into the 2nd amps input?

You'd want to go speaker out to the bray, out of that into your effect set completely 100% wet and from the effect out into the input(or effect return) of the second amp set completely clean.

 

[LLEADD]

I ordered a Bray.
So if I go speaker out of my plexi (I only have one speaker out) into the line out box, out of that into....a 2nd amps send, then the effects rack, then the 2nd amps return, then out to the cabinet?
Or do I have to go into the 2nd amps input?

You'd want to go speaker out to the bray, out of that into your effect set completely 100% wet and from the effect out into the input(or effect return) of the second amp set completely clean.

ok thanks.
Near the end of that chain can you go effects out into the cabinet?

 

[tfridgen]

Nope, you always need a poweramp before the cab.

 

[JediNinjaKnight]

This works just fine and is only $40:

http://www.behringer.com/EN/Products/GI100.aspx

 

[74JMP]

I was looking at the Bray and the Suhr as well. I ended up going with the Bray and it works perfectly. I go out from the bray into FX unit and then into a clean amp. Lots of options and sounds really good.

 

[LLEADD]

I was looking at the Bray and the Suhr as well. I ended up going with the Bray and it works perfectly. I go out from the bray into FX unit and then into a clean amp. Lots of options and sounds really good.

Where do you have the dial set on the Bray?
Is it just for level?