Low Profile MIDI Connectors?

[dfrattaroli]

I'm looking around for a low profile MIDI connector to go from my Musicomlab 62M to Timeline and then Mobius. Not a lot out there but I did find the One Control Hammer MIDI Cable. Looks like a great idea but I don't think you can get it here. Any other options besides this and the Neutrik NYS322? (Which is not very low profile.)

Thanks.
Dave

 

[toddbz]

Can you use a 90?
http://www.redco.com/Switchcraft-05DL5MX.html

 

[dfrattaroli]

Can you use a 90?
http://www.redco.com/Switchcraft-05DL5MX.html

Those might work if I push my TL and Mobius to the very back edge of the board.

 

[nevusofota]

I believe I found these at Redco.

 

[toddbz]

I haven't seen those Hicon ones on Redco, but those are slick!

Super sanitary board, BTW

 

[nevusofota]

I haven't seen those Hicon ones on Redco, but those are slick!

Super sanitary board, BTW

Thanks. The Hicon connectors are quarter inch. The two connectors on the far right of the Timeline are the low profile midi connectors.

 

[toddbz]

I haven't seen those Hicon ones on Redco, but those are slick!

Super sanitary board, BTW

Thanks. The Hicon connectors are quarter inch. The two connectors on the far right of the Timeline are the low profile midi connectors.

Those midi's still look smaller/lower than the Switchcraft ones

 

[nevusofota]

I haven't seen those Hicon ones on Redco, but those are slick!

Super sanitary board, BTW

Thanks. The Hicon connectors are quarter inch. The two connectors on the far right of the Timeline are the low profile midi connectors.

Those midi's still look smaller/lower than the Switchcraft ones

They are, probably can't get any lower.