Marsha Switching Question

  • Thread starter Thread starter rupe
  • Start date Start date
rupe

rupe

Active member
Hey Dave! You currently have my Marsha set up with a stereo jack controlling the clean/OD channels and effects loop, and a seperate mono jack controlling the second set of gain/mv controls. Would it be a simple procedure to change the stereo jack to control the channels and gain/mv controls and move the loop to the mono jack?
I've decided to use this amp for my blues gig so I would like to use the two-button switch to control those functions...I don't need loop switching as I don't use any effects for this gig. I typically use an RG-16 to control everything so it didn't matter, but I plan on leaving the rack at home. Thanks :thumbsup:
 
Sure its swapping 2 wires. The one on the ring of the stereo jack is the loop. Swap the tip wire of the other jack. Thats it.
 
You must log in or register to reply here.
Back
Top