AmpliFIRE
Well-known member
Do you have to add the tx4 recto board in order to upgrade the software in an early v1 to 2.0?
TheGreatGreen
Well-known member
Is adding the board even something you can do? I thought the one that has them just has them, while the ones that didn’t were made entirely differently.
AmpliFIRE
Well-known member
Yes, but that was in the past. They ran out of boards a while back. This is what is all over the web, but it doesn’t clarify to me wether the board upgrade is mandatory for software 2.0
Version 2:
Serial #T1631 to T5199 - 1/25/1993 - Version 2.0 Software & TX4 Recto circuit board installed. The new software allows for Continuous Control of parameters via midi and these parameters scroll faster than in Version 1 units. With the TX4 Recto circuit board for Ld1 Red is added, Ld1 Red Mode is changed from the “British Lead” circuit to the Recto Vintage circuit. The Lead modes have their levels increased (to balance with the Rhythm modes), and the Record Outs are matched for Stereo use. The taper and value of the Bass, Mid, and Ld1 Drive are also changed, along with their respective calibration settings. Many units prior to #1631 have since been updated to Version 2.0/TX4. The easiest way to tell is that when the unit is first turned on, the parameter windows will show “2.0” for a couple of seconds before indicating their settings.
AmpliFIRE
Well-known member
Anyone?
skoora
Well-known member
Call or email Boogie on Monday. They can probably just tell you.