Peavey 6505 + head adding a choke !!

  • Thread starter Thread starter ampnut
  • Start date Start date
A

ampnut

New member
Yo'
alright somebody out there should be able to tell me what i did wrong in the adding of a choke to my 6505+ ??
From everything i've read and have been told, I removed the 400 ohm pwr resistor that was on the power board between the plate and screen nodes, next to the standby switch in the circuit, installed and wired up the mercury choke, in this fashion, and it sounds great, but after awhile of playing when i put the head back on "standby " I get "POP" through the speaks !!!???
the resistance in the choke is around 300 ohms, so the resistance value isn't off that much to make the pop ??? is it ?
What did i miss ?? Cap to ground ??

someone please help !!!!!!!!any help would be awesome !
scott
 
Back
Top