Simple preamp switching solution?

  • Thread starter Thread starter rsm
  • Start date Start date
rsm

rsm

Well-known member
Let's say I have three preamps in a rack, where I want to be able to switch between each so only one preamp is active in the signal path at a time.

Only one preamp has MIDI (or I'd just use MIDI mappings; ideally tone suckage would not be a problem)

What options are available to do this?

Thanks.
 
rsm":3rtok155 said:
Let's say I have three preamps in a rack, where I want to be able to switch between each so only one preamp is active in the signal path at a time.

Only one preamp has MIDI (or I'd just use MIDI mappings; ideally tone suckage would not be a problem)

What options are available to do this?

Thanks.

I think is what the RJM RG-16 is designed for.
 
Thanks, I think the RJM RG-16 is overkill. Who makes a 3-way looper?

I found the Morley ABC pedal, but then I have to run this on a pedal board with three cables to the rack. It also allows you to have one, two or three channels on, so I could use this on the output side to combine the three outputs into one. Same on the front side, being careful/sure to only have one channel on at any time. I'd prefer to have the preamp selection MIDI controlled though, mapping MIDI programs to A, B or C, then I'd only need a MIDI controller on the floor.

Does anyone make a 3-way / ABC switch that is MIDI controllable?
 
muudrock":a8435zjd said:
http://www.axess-electronics.com/sc/GRX4-Guitar-Router-Switcher-p-16135.html

Axess GRX-4. $259 and small. Great unit!


That's it! :clap:
\:D/

Thanks!

(well, I need to read the manual now...)
 
Back
Top