Split Guitar Input Signal in Rack?

  • Thread starter Thread starter spoon
  • Start date Start date
S

spoon

New member
I am adding a rack interface panel to my rack and I want to split the input signal.

I want to have the main guitar input on the panel go to a splitter that sends one signal thru the rack and one signal that goes to a dedicated rack tuner.

Any recommendations on what type of splitter box I should use for this application? Preferably a splitter that does not require a power source if that is possible?

Thanks for the help!
Cheers!
Scott
 
Here are the units and signal flow that I am using.

Rack contains:
Line 6 Relay Wireless
Korg DTR 2000 Tuner
Dunlop Rack Wah
Decimater Pro G
TC G Major 2

Signal path:
Input to rack interface panel via wireless or if wireless fails cable

from main input split to 2 paths:
Path 1 - Korg tuner which then sends signal out to tuner on pedal board

Path 2- Input of Dunlop rack wah - volume controlled by vol pedal on pedal board via VCA
from wah into Decimater Channel 1 then to front of amp.

Effects loop from amp sends to Input 2 of Decimater then to input of G Major 2 then to effects return of amp.

Controlled via Ground Contol Pro and RJM Mini Amp Gizmo
 
Split after the ch1 of the decimator to the tuner. It's buffered and would be a good place to take it from.
 
You must log in or register to reply here.
Back
Top