scottosan
Well-known member
Day 1. Not a bad morning. Just need to add diodes and electrolytic and socket the ICs. Waiting for the pots to come in.
scottosan
Well-known member
psychodave
Well-known member
Look cool.
I built the Ceritone klon and I really like it.
I built the Ceritone klon and I really like it.
scottosan
Well-known member
Do you ever run it in front of the CCV channel 1? In my CCV clone, my Mythical Overdrive is ridiculous into channel 1 pushed.psychodave":2yr6gdq3 said:
scottosan
Well-known member
Good news and bad news.
Bad News -While drilling the enclosure, the bit got caught and the enclosure flew across the garage and didn't survive.
Good new - I had to go with a little bit more polite theme and used an enclosure intended for something else, but it's done.
I just need to tidy it up in the morning. The wiring isn't the cleanest as kind of crudely put it in to make sure there where no issues before I made everything neat. I did a few minutes of A/B'ing with the Mythical Overdrive and they're pretty close. the MO sounds a tad warmer and mine sounds a tad clear clearer on top. That said, I measured the tone pots on each and the MO was at 9.3k and mine at 10.5k, so I would need to turn the MO tone just a little to match mine. I will measure out the gain and volume pots in the morning as well, but so far I'm pretty happy.
I put dip switches on as well so I can toggle back and forth between low and high clippers
photo sharing
Bad News -While drilling the enclosure, the bit got caught and the enclosure flew across the garage and didn't survive.
Good new - I had to go with a little bit more polite theme and used an enclosure intended for something else, but it's done.
I just need to tidy it up in the morning. The wiring isn't the cleanest as kind of crudely put it in to make sure there where no issues before I made everything neat. I did a few minutes of A/B'ing with the Mythical Overdrive and they're pretty close. the MO sounds a tad warmer and mine sounds a tad clear clearer on top. That said, I measured the tone pots on each and the MO was at 9.3k and mine at 10.5k, so I would need to turn the MO tone just a little to match mine. I will measure out the gain and volume pots in the morning as well, but so far I'm pretty happy.
I put dip switches on as well so I can toggle back and forth between low and high clippers
photo sharing
