TubeSync Bias engine

[blackba]

Apparently some manufacturers are using this circuit in their amps. Here is a retro fit kit: http://tubesync.co.uk/tubesync-bias-engine-v4-382.htm

Anyone tried one of the TybeSync products, I just heard about them today.

 

[jerrydyer]

if your apt enough to install that then bias a couple of tubes is really no big deal. I dont think this will take off very well.

 

[moltenmetalburn]

Wow! I would love to try one out. No mods necessary for it either!

 

[Marshall Law]

if your apt enough to install that then bias a couple of tubes is really no big deal. I dont think this will take off very well.

+1

 

[moltenmetalburn]

if your apt enough to install that then bias a couple of tubes is really no big deal. I dont think this will take off very well.

Not sure what you're getting at here. This does a lot more than just bias the tubes statically.

It Is constantly adjusting the bias of each tube individually in real time .

No more matched sets necessary.

Any tube type can be used.

It makes any amp switchable to 50 watts.

You can mix tube types.

You can change all the parameters via a computer.
It rums the tubes cooler and extends tube life.

Im sure you're right and it wont catch on with more than the tweakers and the amp companies that liscence the design such as Howard.