Two speaker cabs with Tweaker 88 ?

  • Thread starter Thread starter johnnyguitar
  • Start date Start date
J

johnnyguitar

New member
Can I run 2 separate speaker cabs - for example, two 2x12 cabs, out of my tweaker 88?
If each cab is 8ohm, I just set it to 4ohm - is that correct?
If so, I don't suppose I can use my stereo tc electronic reverb pedal to get true stereo ?
 
yeah 2 cabs just make sure theyre both 8 ohm cabinets.

then you set the amp to 4 ohms.

the definition of true stereo is two power supplies. two amps. this is just two speaker cabs being fed with one amp. its still mono. Also there is only 1 input into the amp, you cant run two outputs from the pedal into 1 input and get stereo. The reverb would sound better in the FX Loop though.
 
Thanks for the confirmation.
I realise that anything before the amp or in the effects loop (my reverb is here anyway) - will all be mono.
I just wondered if there was anyway to split the signal coming out of the back of the amp - into some stereo gizmo/splitter - to then feed 2 cabs in stereo?
 
No such box. Your reverb has 2 outputs for people who use stereo setups and need a stereo split to feed 2 amplifiers.
 
You must log in or register to reply here.
Back
Top