Using Timefactor as single effect for 2 amps in the loop?

[memberzonly]

Is it possible to use the TF (or any effect) in the loop of two amps?

As an example, if I have amp A set to clean and amp 2 distorted, can I use a 'Y' cable from the send of loop A and send of loop B into the TF then use the out of the TF into a splitter cord back to each amp's loop return?

Will it work? What is a better way?

 

[Cirrus]

It would work, but I don't know why you're talking about a y splitter cable or an adapter. The Timefactor has a left input, a right input, a left output and a right ouput. So the loop send of amp a would go to left input, then left output would go to the return of amp A. loop send of amp b would go through the right input/output, then back to amp b loop return.

You'd likely run into ground loop trouble though, and I think on some of the presets that pan you might get the left/right signals mixing together but as long as you stuck to the simple dual delay functions it'd do it.