VH4 delay/reverb loop question

  • Thread starter Thread starter Axegrinderturbo
  • Start date Start date
Axegrinderturbo

Axegrinderturbo

Member
Hi guys,

Sorry if this sounds basic but I'm working on two setups with my vh4, a g system for bigger gigs and a small board for smaller gigs.

Re the smaller board I have a tubescreamer, wah, tuner, flashback x4 delay, reverb and phaser pedal.
I was planning on splitting the board in half with the delay, reverb and phaser going to the loop and rest in front of the amp.

Would you say this is the best way running the 3 pedals into one of the loops? Parallel or serial???

Many thanks in advance!

Stu
 
I'd use a serial loop to avoid phasing issues. You can set the mix on each pedal.
 
Thanks for the reply,

From the send would run the pedals in any order, delay first, reverb then phaser or does it not make much difference??
 
Hm, just try what you like best... I'd use the reverb as the last pedal. With phaser and delay it might be interesting to try different orders. You can modulate the repeats with the phaser when you run the delay into it. That sounds a lot like the stuff from Mike Einziger..
 
Thanks again for the reply, appreciate it! Will give it a go tonight
 
You must log in or register to reply here.
Back
Top