JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
WTB: Mesa/Boogie Plate Amp Logo -1 5/8" Tall, 9 5/16" Length, 8 13/16" Hole Spacing
Thread starter Thread starter
Six Stringer
Start date Start date
Dec 9, 2021
To buy, sell, or trade in this section, you must have at least 50 posts and have two-factor authentication enabled.
Six Stringer Active member
I am looking for a Mesa/Boogie Plate Amp Logo, 1 5/8" Tall, 9 5/16" Length, 8 13/16" Hole Spacing. There's a short amp badge and a longer one. I need the larger one. This is the printed logo on aluminum.
Last edited: Dec 22, 2021
ClintN667 Well-known member
Have you checked with Mesa? Their parts shop has several of the badges
gbsmusic Well-known member
Have you checked with Mesa? Their parts shop has several of the badges
They do have them I almost bought one a while back and they're not that much money if I remember right.
Six Stringer Active member
Have you checked with Mesa? Their parts shop has several of the badges
They do have them I almost bought one a while back and they're not that much money if I remember right.
I have checked with them already. They have a few of the short ones but not the one I am after. They do not have the short ones listed on their parts website.
Exo-metal Well-known member
I need a 2C+ faceplate for anyone out there.
psychodave Well-known member
Six Stringer Active member
It's like that but I need the larger version. Hole Spacing is 8 13/16"
Six Stringer Active member
Still trying to locate one.
Six Stringer Active member
Outside dimensions added. I'm in dyer need of this.
Six Stringer Active member
Six Stringer Active member
Corrected measurements - 1 5/8" Tall and 9 5/16" Length.
Six Stringer Active member
It's not looking too good.
