I retubed my Einstein about a month ago. All was working great, then I plugged my amp into my recently repaired reactive load IR and the mains fuse and the inner tube fuse blew. I contacted Suhr and they said the reactive load box had been tested and it wouldn't have blown the fuses. Not sure what the issue is, but the inner tube fuse exploded and half of the fuse is stuck inside. Anyone have this issue before and have any recommendations for getting the broken part of the fuse out?
Diezel Einstein Fuse Issue
- Thread starter joafink2
- Start date
Peter Diezel
Well-known member
We don´t recommend other loads than speaker cabinets and
one of the new power tubes seems to be bad.
Please UNPLUG the amp and take the chassis out of the head
shell. With a small screw driver you may remove the rest of
the fuse from the back of the fuse holder.
Please get a 0.5 amps slow blow ceramic fuse.
Best regards,
Peter
one of the new power tubes seems to be bad.
Please UNPLUG the amp and take the chassis out of the head
shell. With a small screw driver you may remove the rest of
the fuse from the back of the fuse holder.
Please get a 0.5 amps slow blow ceramic fuse.
Best regards,
Peter