rchrdnaylor
New member
Hi - I recently got a 2x12 D212R-C BK cab for my D-Moll. It sounds great but here are a couple of questions:
1. It didn't come with any castors - should it? Or do I need to buy these separately?
2. Whenever I buy a new cab like this I go round all the screws to tighten them up just in case. For this cab that was fine except a screw in the middle of the back panel around 2/3rds of the way towards the top. This screw just turns and turns freely without tightening (there was never any real 'purchase' on the screw). From looking at a picture on the website it seems this is a wooden panel with the screw going directly into end-grain wood so this could have already been stripped when it arrived. Does this matter? Is this screw integral to the structure of the cab? It will hold itself in place ok but will it make a difference to the sound of the cab if it isn't screwed in tight?
You can see the panel on one of the pictures here:
https://www.diezelamplification.com/cabinets/
Thanks in advance!
1. It didn't come with any castors - should it? Or do I need to buy these separately?
2. Whenever I buy a new cab like this I go round all the screws to tighten them up just in case. For this cab that was fine except a screw in the middle of the back panel around 2/3rds of the way towards the top. This screw just turns and turns freely without tightening (there was never any real 'purchase' on the screw). From looking at a picture on the website it seems this is a wooden panel with the screw going directly into end-grain wood so this could have already been stripped when it arrived. Does this matter? Is this screw integral to the structure of the cab? It will hold itself in place ok but will it make a difference to the sound of the cab if it isn't screwed in tight?
You can see the panel on one of the pictures here:
https://www.diezelamplification.com/cabinets/
Thanks in advance!