Rig-Talk

Guitars, Gear, Tone!
It is currently Thu, Nov 21, 2019 7:04am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu, May 19, 2016 10:09pm 
Offline
Hack

Joined: Thu, May 19, 2016 10:00pm
Posts: 1
Are you human?: 951
Hi,

I have an Egnator Rebel 30, with a matching 1x12 extension cab.

Recently, the amp stopped working with the extension cab plugged in.
( yes I set the impedence switch to 8 ohms with the ext cab)

It does not cut out completley, I can still hear a very weak (kind of noisy) signal.

When I disconnect the extension cab ( and set impedence back to 16 ohms), the amp
performs normally - full power, volume, and clean.

Also - when I disconnect the internal speaker, and plug into the extension cabinet, the amp
is fine - IE the extension cabinet is OK.

Has anyone else experienced this ? Any ideas on what could be wrong ?

Thanks in advance


Top
 Profile  
Reply with quote  
PostPosted: Sat, Aug 10, 2019 10:16am 
Offline
Hack

Joined: Fri, Aug 09, 2019 11:08am
Posts: 3
Are you human?: 951
Maybe look at the expansion jack plug, check the output transformer, check where it connects to see if the spear connectors are tight and check the impedesnce switch. I'm no tech but thats a good place to start. Be careful of high voltages when playing inside your chassis, caps will hold a charge.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group - Terms of Use