Egnater Renegade 65 Head Very Low Volume Clean Channel

jackdvnprt1

New member
So I have this Renegade 65 head i bought used knowing it had a bad input transformer... I had it replaced and worked great for a while... I now have a new issue with very low volume on the clean channel... I have checked and tested every component... I have signal chased through V1 through Relay1 through C5, C6, R7, C7, C10, C11... I have great signal to that point.. Behind C7, c10 and C11... I have a massive signal drop... By the time it gets to R11 its very low... I have tested all Pots in the tone stack along with corresponding caps and resisters... Can someone please turn me onto a Service sheet for this amp so I know what is voltages should be where!!
 
I would check the Plate voltages on all tubes first, make sure your power supply is good. Look for hundreds of VDC.
 
Back
Top