bionicmark
Well-known member
Hello! I was wondering if there are any special tips in running two speaker cabinets with one 100w head?
I have two Bogner 1x12 cubes. Both 8ohm. My concern is phase cancellation. What's the best way to make sure this doesn't happen?
I assume I'd have them foot a part from each other (side by side) and I'm only going to be mic'ing one cabinet. Heil PR30 mic
Obliviously, I'd have the ohm setting to 4ohm on the head.
Thanks in advance!
Mark
I have two Bogner 1x12 cubes. Both 8ohm. My concern is phase cancellation. What's the best way to make sure this doesn't happen?
I assume I'd have them foot a part from each other (side by side) and I'm only going to be mic'ing one cabinet. Heil PR30 mic
Obliviously, I'd have the ohm setting to 4ohm on the head.
Thanks in advance!
Mark