Identifying negative feedback tap

mniel8195

Active member
How do you know which tap goes to which ohm amount? I figure you can turn the know and look inside the switch to see which direction the connection is facing compared to the ohm amount on the impediance selector.
 
mniel8195":2b1b1r5e said:
How do you know which tap goes to which ohm amount? I figure you can turn the know and look inside the switch to see which direction the connection is facing compared to the ohm amount on the impediance selector.


Yes In most cases you can look on the back of the impedance selector to see where the dial is contacted then take note of the ohms. And usually the NFB will be the lug where two wires are connected instead of one.

Sometimes its connected directly to the output jacks.
 
Back
Top