Rig-Talk
https://www.rig-talk.com/forum/

Found out something while slaving my MCI...
https://www.rig-talk.com/forum/viewtopic.php?f=60&t=197729
Page 1 of 1

Author:  Racerxrated [ Wed, Jul 11, 2018 11:43am ]
Post subject:  Found out something while slaving my MCI...

It likes the impedance reduced when using the line out. I've been slaving my MCI to a Roland SDE 1000 through an HH M900, out to 2 Marshall cabs. No loop and I don't want to mess with how great it sounds as is....the M900 is the same as the V800 but fewer in/out options and no VU meters. Sounds great...but I noticed some tone suck from the dry cab which is just coming straight out of the Wizard speaker jack. On a RTers suggestion I reduced the impedance on the amp to 8 ohms and that helped a ton. Just a tip for anyone if they notice a little tone suck if they are slaving...My cabs are Marshall 16 ohm mono.

Author:  ChurchHill [ Wed, Jul 11, 2018 2:51pm ]
Post subject:  Re: Found out something while slaving my MCI...

Interesting... makes sense, though, if the line out is coming off of the speaker jacks. I have a few amps that have line outs that do come off the speaker jacks, so I'll have to try that with those. Thanks for the tip!!

Author:  mhenson42 [ Wed, Jul 11, 2018 2:54pm ]
Post subject:  Re: Found out something while slaving my MCI...

I run my wizards dry into a 16 ohm cab, wet cabs using the line-out. I haven't noticed any tone suck when using the line out. I'll try the lower impedance and see if I notice a difference

Author:  Racerxrated [ Wed, Jul 11, 2018 4:01pm ]
Post subject:  Re: Found out something while slaving my MCI...

mhenson42 wrote:
I run my wizards dry into a 16 ohm cab, wet cabs using the line-out. I haven't noticed any tone suck when using the line out. I'll try the lower impedance and see if I notice a difference

It's pretty minor, not that noticeable but it's there.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/