So I purchased a reload and I can't seem to get anything on the match feature to light up. I figured this would be a quick setup and go but its been nothing but a headache. I know it's on my end I just can't figure it out.
My setup:
RME Fireface UFX
Cubase 7.5
Reload
5150
I'm going out a mono output on my daw. Output 3. I can see signal going out. It goes out via a trs cable to the Line In on the replay section. Which then goes via a TS cable to the 5150 from the amp out. The speaker out on the 5150 goes to the Speaker in on the Reload. Both set at 8 OHMS. Then I have a XLR going from the Loadbox out on the reload to the front of my interface. I use channel 11 on the front as my input for a new channel to record on. When I monitor the signal I don't hear anything but hum. I see signal coming in but it's not guitar. I've tested the amp. I've tested using just a reamp box and both work. So it's got to be a signal issue. I even set my master volume on my interface to -6 to see if that was the reason but it didn't help. All I wanna do is reamp these DI giutars... Someone help....
My setup:
RME Fireface UFX
Cubase 7.5
Reload
5150
I'm going out a mono output on my daw. Output 3. I can see signal going out. It goes out via a trs cable to the Line In on the replay section. Which then goes via a TS cable to the 5150 from the amp out. The speaker out on the 5150 goes to the Speaker in on the Reload. Both set at 8 OHMS. Then I have a XLR going from the Loadbox out on the reload to the front of my interface. I use channel 11 on the front as my input for a new channel to record on. When I monitor the signal I don't hear anything but hum. I see signal coming in but it's not guitar. I've tested the amp. I've tested using just a reamp box and both work. So it's got to be a signal issue. I even set my master volume on my interface to -6 to see if that was the reason but it didn't help. All I wanna do is reamp these DI giutars... Someone help....