So there's two outputs on the Captor but I dont think I understand 100%
1. "Line (dry)" <--- this i DONT understand, I've seen no good demonstration about it on Youtube, they all show the DI output below
2. "DI" <--- this I understand
So I guess the DI is affected by the speaker simulation, so I would use that to connect to FOH, right?
The "Line (dry)" I have not seen any Youtube videos showing what it actually does!!!
Is that just the guitar signal, or the AMP distortion, but without any cab sim so I can use IR on that?
If so that would be awesome. I would like to connect both so I can get the speaker simulated sound out to PA for crowd, and another channel with only amp distortion so I can then mix the live recordings by adding IR cabs in my DAW.
If it's only guitar signal, I guess I have to reamp everything?
1. "Line (dry)" <--- this i DONT understand, I've seen no good demonstration about it on Youtube, they all show the DI output below
2. "DI" <--- this I understand
So I guess the DI is affected by the speaker simulation, so I would use that to connect to FOH, right?
The "Line (dry)" I have not seen any Youtube videos showing what it actually does!!!
Is that just the guitar signal, or the AMP distortion, but without any cab sim so I can use IR on that?
If so that would be awesome. I would like to connect both so I can get the speaker simulated sound out to PA for crowd, and another channel with only amp distortion so I can then mix the live recordings by adding IR cabs in my DAW.
If it's only guitar signal, I guess I have to reamp everything?