the_mcleod
New member
Hi,
I recently got a 8ohm captor and I seem to be getting some clipping when using the unit. I didn't notice it at first as I was using an 'edge of break up' tone but when I try to get a clean tone there is a high end, digital sounding clipping. I'm running a Fender Hot Rod Deluxe/Egnater Tweaker into the captor then into a Steinberg UR28M audio interface. At no point in the signal chain are any indicators showing any clipping so I'm a bit confused. The Fender is set at around 4 on the clean channel volume and the Egnater just above half way but it's only 15w so that shouldn't be causing any issues should it?
Any help would be appreciated.
Thanks
I recently got a 8ohm captor and I seem to be getting some clipping when using the unit. I didn't notice it at first as I was using an 'edge of break up' tone but when I try to get a clean tone there is a high end, digital sounding clipping. I'm running a Fender Hot Rod Deluxe/Egnater Tweaker into the captor then into a Steinberg UR28M audio interface. At no point in the signal chain are any indicators showing any clipping so I'm a bit confused. The Fender is set at around 4 on the clean channel volume and the Egnater just above half way but it's only 15w so that shouldn't be causing any issues should it?
Any help would be appreciated.
Thanks