spikey
New member
Hi, just a quick question (or two) on this if I may-
1. I can't figure out why the lineout of the CAB M is TRS?
Esp If the lineout goes into a 1/4" T/S mixer input channel jack that's usually not TRS?
2. If I connect lineout from the Captor load box into the line in of a CAB M, does this cable need to be TRS as well, and why?
3. Last, which is the "best" way to hook up the two units after leaving the output of an amp?
Thanks!
1. I can't figure out why the lineout of the CAB M is TRS?
Esp If the lineout goes into a 1/4" T/S mixer input channel jack that's usually not TRS?
2. If I connect lineout from the Captor load box into the line in of a CAB M, does this cable need to be TRS as well, and why?
3. Last, which is the "best" way to hook up the two units after leaving the output of an amp?
Thanks!