Switch to full style
Guillaume Pille from Two Notes is here on board to answer all your questions about their amp simulators!
Post a reply

CAB M and bluetooth = 10 seconds to change a param

Sun, Nov 03, 2019 1:07pm

Hi,

I use the CAB M between amp and column. I am using the remote app on a Huawei P20 Pro.

Everything is updated correctly (firmware on the CAB M, last android version on the phone).

When changing a parameter on the phone it takes like 10 seconds before I can hear the change ...

I am placed like 5 meters away from the amp (and the CAB M).

Is it normal? Does it work better with iOS?

Thanks for your return.

Cheers,

PHil

Re: CAB M and bluetooth = 10 seconds to change a param

Mon, Nov 04, 2019 4:37am

Hi philmartins,

there are documented issue between Huawei and Bluettoth LE (the open protocole that we use) because of some choices made by Huawei in terms of hardware architecture. We are trying to make it work better but it's a pain, and Huawei doesn't seem to care.

CAB m works perfectly with iOS, yes.

Re: CAB M and bluetooth = 10 seconds to change a param

Mon, Nov 04, 2019 9:15am

okay I will give it a try ...

Re: CAB M and bluetooth = 10 seconds to change a param

Tue, Nov 05, 2019 3:48am

okay so no issue with iOS. It works perfectly.

With Android it starts well and then after a while the performance is getting worse ... until the point where I have to wait 8 seconds to hear the change.

When I change on the cab m it is direct but 8 seconds from the phone.

Will stay with iOS for this ...

Re: CAB M and bluetooth = 10 seconds to change a param

Wed, Nov 06, 2019 3:32am

Hi philmartins, it's not Android, it's Huawei. Most of our users actually have android phones and it's perfectly OK.

Re: CAB M and bluetooth = 10 seconds to change a param

Wed, Nov 06, 2019 3:50am

okay thanks for the clarification. :rock:
Post a reply