Torpedo Live- Axe FX as Cab Sim
Page 1 of 1

Author:  painkiller [ Sun, Dec 08, 2019 12:08pm ]
Post subject:  Torpedo Live- Axe FX as Cab Sim


i want to recreate that tone of Misha Mansoor.
I use the same Signal Chain except i use the Peavey 6505.
Can anybody help me how i do this.. i mean how do i connect everything.


mm.PNG [ 67.63 KiB | Viewed 1481 times ]

Author:  shawnb [ Mon, Dec 09, 2019 1:27pm ]
Post subject:  Re: Torpedo Live- Axe FX as Cab Sim

I bought a Torpedo Studio last week and spent a tremendous amount of time trying to figure out a similar setup. As far as I can tell, this will work with the Torpedo Live, also. Here's what I did:

1) Axe FX 3: In the Global Settings menu, disable AMP modeling. Enable CAB modeling.
2) Torpedo Remote: Turn Miking OFF

Here's my signal flow. I write Torpedo Studio, but this *SHOULD* work with the Torpedo Live just the same.

File comment: AXE FX 3 to Torpedo and Back
AXE Flow.png
AXE Flow.png [ 69.56 KiB | Viewed 1421 times ]

* I use AXE FX Ouput1 -> ears because I monitor with my headphones even though I DI via USB
* I Use ... -> Torpedo -> AFX3 INPUT2... because of a technical reason that doesn't apply to the Live. You can use any of INPUT 2/3/4 with your setup and any OUTPUT of 2/3/4 to the Torpedo

You're using an external effects pedal, also. It would be similar... you would make one of the following changes from what you see in the signal flow I show above:

[Option 1]
Guitar -> Pedal -> Axe FX 3 [input1] -> Etc.

[Option 2]
Guitar -> AF3 [Input1]--[etc]--[Output3]--> Pedal -> AF3  [Input3]--[etc]--[Output2]--> Amp --> Live --> AF3 [Input2]--[etc]--[cab]--[etc]--[Output1]

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group